How-To Guides

If you have an awning on your RV, chances are you will need to clean it at some point. A magic eraser is a great tool for cleaning an awning because it can remove stubborn dirt and stains. To clean your RV awning with a magic eraser, simply wet the eraser and scrub the awning in a circular motion. Be sure to rinse the area afterward to remove any residue. How to Clean RV Awning […]

To clean a wool saddle pad, first, remove any dirt or debris with a brush. Then, soak the pad in cold water for about 15 minutes. Next, use a mild soap to gently scrub the pad. Finally, rinse the pad thoroughly and allow it to air dry. How to Clean Wool Saddle Pad Saddle Pad Cleaner When it comes to keeping your horse’s tack clean, one of the most important things to remember is to

To clean your Promethean Board, start by unplugging the power cord and removing any cables. Next, use a dry or damp cloth to wipe down the surface of the board. If there are stubborn marks, you can use a mild soap and water solution. Be sure to dry the board thoroughly before plugging it back in and using it again. How to Clean Promethean Board Promethean Board Tutorial Promethean Board Tutorial Do you want to

The best way to clean a copper still is to use mild detergent and warm water. Rinse the still with clean water and then dry it thoroughly. You can also use a commercial copper cleaner, but be sure to follow the instructions carefully. How to Clean a Copper Still Cleaning Still between Runs Cleaning still between runs is crucial to maintaining a high-quality product. If your still is not cleaned between runs, your product will

To clean a Lululemon yoga mat, start by wiping it down with a damp cloth. If there are any stubborn dirt or sweat stains, use mild soap and water to spot-clean them. Once your mat is clean, dry it off completely before storing it away. To extend the life of your mat, try to clean it every few uses. How to Clean a Lululemon Yoga Mat How to Clean Lululemon Yoga Mat Reddit If you

To clean a lanyard, first, remove any attached objects. Next, soak the lanyard in warm water with a mild detergent for about 5 minutes. Then rinse thoroughly with clean water and allow it to air dry. If the lanyard is heavily soiled, you may need to repeat this process. How to Clean Lanyards How to Clean a Fabric Lanyard If you’ve ever worn a lanyard with your ID badge to work, then you know how

To clean a copper water bottle, mix 1 tablespoon of salt with 1 cup of vinegar. Place the mixture in the water bottle and shake well. Let it sit for 5 minutes, then rinse with warm water. Repeat if necessary. How to Clean a Copper Water Bottle How to Clean Copper Water Bottles Inside If you’re like me, you love your copper water bottle. Not only does it look great, but it also keeps your

To clean your cooling towel, start by soaking it in cool water for 5 minutes. Then, add a mild laundry detergent and scrub the towel with your hands to work in the soap. Rinse the towel thoroughly under cool water until all of the soap is gone. Finally, hang or lay it flat to dry completely before using it again. How to Clean Cooling Towels Frogg Toggs Cooling Towel Cleaning Instructions Frogg Toggs Cooling Towel

Start with the outside of the car and use a soft cloth to wipe down the body; if there are any spots that seem especially dirty, you can use a mild soap and water solution to help clean them. Once the body is clean, move on to the tires; use a damp cloth to wipe down each tire, paying special attention to any dirt or grime that may be caked on. Next, focus on the

To clean your valve cover gasket, you will need a few supplies. You will need a putty knife, a screwdriver, and some rags. First, use the putty knife to scrape off any old sealant that may be on the gasket. Next, use the screwdriver to remove any dirt or debris that may be stuck in the gasket. Finally, use the rags to wipe down the gasket and remove any remaining residue. How to Clean Valve

Start with a small amount of sand and add water. The ratio of water to sand should be approximately 1:10. Use your hands to mix the water and sand together until the sand is fully saturated. Allow the wet sand to sit for a few minutes so that any impurities can settle to the bottom of the container. Carefully pour off the dirty water, being sure not to lose any of the wet sand. How

To clean your Uline ice maker, first, unplug it from the power outlet. Next, remove all of the ice from the unit and discard it. Then, using a mild soap and warm water solution, wipe down the interior surfaces of the unit. Be sure to also clean the exterior surfaces, including the door gasket. Once you have finished cleaning the unit, allow it to air dry completely before plugging it back in and turning it

To clean a Styrofoam incubator, first, remove all of the eggs and any other items from the incubator. Next, use a soft cloth or brush to gently remove any dirt or debris from the inside of the incubator. Once the interior is clean, wipe down the outside of the incubator with a damp cloth. Allow the incubator to dry completely before using it again. How to Clean a Styrofoam Incubator How to Clean Styrofoam Cooler

To clean your Nuna Rava’s car seat, first, remove the seat cover and machine wash it according to the instructions on the label. Then, use a damp cloth to wipe down the seat itself, paying special attention to any areas that are sticky or dirty. If you have any stubborn stains, you can try using a mild soap or detergent. Once you’re finished cleaning, make sure to dry the seat completely before putting the cover

Banjos are traditionally made of wood and can be delicate instruments. You will want to take care when cleaning your banjo to avoid damaging it. Start by removing the strings from your banjo. Use a soft, dry cloth to dust off the body of the banjo, taking care not to scratch it. You can use a slightly dampened cloth to wipe down the neck and headstock. Be sure to dry the banjo completely before replacing

To clean a swim cap, first, rinse it in cool water to remove any chlorine or salt water. Then, using mild soap, lather the cap and rub it gently all over. Rinse the soap off with cool water and let the cap air dry. How to Clean Swim Caps How to Remove Mold from Swim Cap If you’re like me, you love swimming but hate the pool water getting in your hair. And if you

To clean your Pit Boss Pellet Grill, first, remove the pellets from the hopper. Next, use a soft bristle brush to clean the inside of the fire pot. Be sure to also wipe down the outside of the fire pot. Then, using a vacuum cleaner with a brush attachment, vacuum out any debris from the inside of the grill body. Finally, use a damp cloth to wipe down the exterior of your grill. How to